Quick recap on what "structured water" is.. Assuming that water is just H2O, is like assuming clay is always clay, when you can craft the most beautiful ceramics ever, enormous difference to a muddy puddle, even if the molecular makeup is identical.

The brilliant scientist Jacques Benveniste found that water does in fact act like the clay in my analogy, if you let water interface with something, let's say blueberries, it will "remember" the blueberries, even if you remove them.

Benveniste found that the "memory" of the blueberries will multiply to more water, if you shake it. I guess this implies that the ocean remembers everything that ever happened. Pretty cool. Anyways - this "memory" is NOT what I have improved upon today.

The important discovery I have to share, is how to make a different kind of water, on a molecular level. I found it when I was making an electrical waterfall. Waterfalls feel AMAZING when close, and we know this is because the air around it is filled with negative ions.

There are electrical negative ion generators you can buy, they try to electrify the air, which is nearly impossible, so it mostly electrifies pollution in the air, so instead of having neutral dust, you have electrically charged dust that clings like a magnet to anything.

Negative electrical charge feels good, but there is something special about waterfalls. The negative ions from waterfalls is a special type of water!

Normally, water is H2O. A tiny bit of it will break apart into H3O2+ and OH- which are positive and negative charges in the water. In chemistry, you always have the same quantity of both.

Waterfalls don't care about chemistry. They will break the water liquid apart into droplets, separating the OH- and H3O2+ ions from each other.

When you break water apart, smaller droplets will more often have negative charge, and the larger bulk water will more often have positive charge - I think this is because surface tension is typically negative.

Hence - waterfalls release a bunch of OH- ions into the air. The charge from this water is so high that water molecules are instantly attracted to it, so you have OH- covered with between 3 and 20 normal H20 molecules.

The amount of OH- produced, even by a large waterfalls, is not large. The euphoric feeling you get by being close to the Niagara Falls, we are talking about maybe 10,000 molecules of OH- per cm3..

So, we have 10,000 of these magic OH- and do you know how much regular H2O we have in the humidity in the same volume of air? Approximately 694,000,000,000,000,000 regular H2O molecules.

Now, it is time to tell you what I found. An incredibly simple way to produce unlimited amounts of OH- water. To make this blessed water, we are also generating an equal amount of cursed water. This should be thrown into the ocean or a desert or something.

You can run an electrical current through water, this is called electrolysis and it goes like this.. We put one negative wire into one side of the water, and one positive wire on the other side.

To allow the current to flow out of the wires, water has to break apart to make ions. At the positive wire, there will be H2 gas bubbling up, and at the negative wire, there will be O2 gas bubbling up. In the bulk water, the available dissolved ions will let the current flow.

At the positive wire, we will generate cursed water, acidic, plenty of H3O+ At the negative wire, we will generate blessed water, alkaline, plenty of OH-

Now, we generate an equal amount of these, as chemistry dictates.. But there is nothing stopping us from having the electrodes spaced far apart! This allows us to generate the ions with large separation. Time for a demonstration!

We start by extracting some anthocyanins from red cabbage, because anthocyanins change color when they lose or gain electrons, allowing us to see what's going on in the experimental water.

We will use a regular 9 volt battery as the power source, added a little bit of salt to increase the current to 0.005 ampere. This setup is inefficient, so we will we wait a few hours now..

Would you look at that :) The left side is cursed, acidic, filled with H3O+ The right side is blessed, alkaline, filled with OH-

So, on the right side, we have a HYPER-CONCENTRATED version of what we see in the air surrounding waterfalls, OH- with no H3O+ We can see it is pH 14, so we have approximately 100,000,000,000,000,000,000,000 OH- ions on the yellow side.

When you visit a waterfall, you will interact with maybe 1,000,000 OH- ions or something like that. This is a ridiculously powerful method, very close to 100% efficiency from energy source to deposited energy in the water.. Time to look closer at the water. It is bizarre!

The blessed water has CRAZY strong surface tension It does not lie flat, the electric forces are far stronger than gravity. The surface bends, is highly concave, since the surface tension is negatively charged, and like charges repel. The water is thick, almost like a gel.

The toxic water also has a little bit of a bend, but not nearly as much - surface tension can be positively charged. Touching the surface of the cursed water is even worse than touching the bulk of the cursed water, the surface of water is like the tip of a spear.

When you shine light into the two glasses, there is a very obvious difference.. The blessed water bends the light outward, radiating its color everywhere. The cursed water simply consumes the light. Murky and dark, and despite having lots of color, it does not radiate the color.

When you have OH- in the air, they are electrically attracted to the positively charged sky, so they are dragged upwards, which means that clouds & rain have lots of OH- Are you starting to see why you see rainbows after it rains, or near waterfalls?

When you swirl the blessed water around, it clings to the walls of the glass. You see this behavior in OH- rich rain, but not with dead water, which has weak surface tension, and simply falls down.

In the 1960s, the Soviet scientist Nikolai Fedyakin had a complicated non-electrical method to achieve the same thing, he filtrated pure water through very low diameter quartz tubes. He measured the shocking physical properties of the water..

Boiling point was over 150°C/300°F Density was 1.1 - 1.2 g/cm3 Freezing point was less than −40°C/-40°F Are you starting to see why "natural water" is more hydrating, and that "dead water" is unable to stay in the body?

Let's talk about Viktor Schauberger. He was a forest caretaker, who studied living water, and achieved "impossible" engineering feats with it. He made water flow uphill (this is also described in the bible btw, ref:Wiki article "Living water")